John Deere 450H, 550H, 650H — Hydrostatic Transmission

Miscellaneous—Troubleshooting Hydraulic System Symptom Problem Solution Blade Lifts and/or Blade Tilts Too Slowly Cold oil Allow oil to warm up. Oil viscosity too high (too thick) Use correct oil. Control valve linkage Inspect linkage. Repair or adjust. See your authorized dealer. Worn hydraulic pump Check blade raise cycle time. Blade Fails to Lift and Blade Fails to Tilt Low hydraulic oil level Check. Add hydraulic oil. Blade Hard to Control Front idler vertical movement excessive Adjust front idler to side frame clearance. Pump Excessively Noisy Cold oil Allow unit to warm up. Low oil level Check, add oil. Oil viscosity too high (oil too thick) Change oil to correct viscosity oil.

Hydraulic Oil Overheats Operator holds control valve open too long, causing system relief valve to open Instruct operator on correct operation of dozer. Oil viscosity too high (oil too thick) Change oil to correct viscosity. Hydraulic Oil Foams Water in oil Inspect oil. Change. Using wrong oil Inspect. Change oil. HG31779,00000D4 -19-14JAN08-1/1 4-3-7 070813 PN=163