Safety - Section 2 OM2005.2 10/96 Page 2-6 Warnings and Cautions The welding "Caution" plate WA9713 is located in the cab above the windshield. These instructions MUST be followed when welding is done on the truck to avoid damage to the ATEC components. WA9779 Caution decal is located in the cab on the back of the sunvisor and specifies that during first four hours of operation, the Truck Speed SHOULD NOT Exceed 25 MPH (40 KPH) in order to properly break-in the oil brake seals. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . On the right side of the operator’s instument panel is a series of three Warnings.
The Warning on the left specifies that wheel brake lock is not to be used for parking . If engine is not running, brake pressure may bleed down allowing brakes to be released. It should be used only at the shovel or dump, or for emergency. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A ROPS/FOPS Warning plate is located on the right side of the cab above the windshield. It specifies that the structure as manufactured meets SAE specifica- tions and warns that these specifications may be im- paired if subjected to any modifications or damage. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .