OM3005.2 Operation - Section 3 Operator Cab and Controls Page 3-11 OPERATOR CONTROLS AND EQUIPMENT FIGURE 3-2. OPERATOR CONTROLS 1. Steering Wheel 4. Horn/Telescope Adj. 7. Service Brake Pedal 10. Ash Tray 2. Turn Signals 5. Hoist Control 8. Throttle Pedal 11. Range Selector and Dimmer Switch 6. Retarder Pedal 9. Cigarette Lighter 12. DO NOT SHIFT Light 3. Steering Wheel Tilt Lever Not Shown - HAZARD Flasher Switch below Steering Wheel (1) Steering Column And Controls (3) Tilt Lever The steering column will tilt up and down and telescope in and out to provide a comfortable drive position for the operator, or move up and away for easy entry and exit.
Adjust the tilt of the steering wheel by pulling the Tilt Lever toward the steering wheel and moving the wheel to the desired angle. Releasing the lever will lock the wheel in the desired location. (2) Dimmer Switch And Turn Signals (4) Horn And Telescoping Adjustment The dimmer switch is located in the turn signal lever. If headlights are on low beam, pulling the lever toward the steering wheel will change headlights to high beam. Pulling the lever again changes headlights back to low beam. The horn is activated by depressing the center "button". Operation of the horn should be verified before starting engine or moving truck.
The steering wheel adjustment may be moved "in" or "out" (telescoped) by rotating the housing around the horn button counterclockwise to unlock the adjust- ment. After selecting the desired position, rotate the housing clockwise to lock the adjustment. Turn signals lights are activated by moving the lever "up" to activate right turn lights, and moving the lever "down" for left turn lights.