Komatsu — CHECK BEFORE STARTING ENGINE

. OPERATION OPERATION 12. Inspect tires. WARNING If worn or damaged tires are used, they may burst and cause serious injury or death. To ensure safety, do not use the following tires. Wear: Tires with a tread grooves of less than 15% of that of a new tire Tires with extreme uneven wear or with stepped-type wear Damage: Tires with damage that has reached the cords, or with cracks in the rubber Tires with cut or pulled cords Tires with peeled (separated) surface Tires with damaged bead Leaking or improperly repaired tubeless tires Deteriorated, deformed or abnormally damaged tires, which do not seem usable 13. Inspect rims.

WARNING Check the rims (wheels) and rings for deformation, corrosion and cracks. In particular, check the side rings, lock rings and rim flanges thoroughly. 3 - 61 8. Check for damage to gaug es, lamps on the instrument panel an d loose bolts. heck for damage to the panel , gauges and lamps. If any problem is found, replac e the parts. Clean off any dirt on e surface. Tighten any loose 9. Check rear view mirror, un der view mirror heck that the mirrors are not damaged. Replace them if they are d amaged. Clea n the surface of the mirrors and djust the angle so that the op erator can see the area to the rear an d under the m achine from the oper ator's seat. 0.

Check for damage to the s eat belt and mounting clamps. and mounting clamps. If damages are found, replace with the new one. the clamps mounting the equipment to the machine. Tighten any loose bolts. heck for damage to seat belt and mounting clamps. If damages ar e found, repla ce with the new one. Check for any loose bolts of the clamps mounting the equipment to the machin e. Tighten any loose When the belt has been use d for a long time, if any external dama ge or fraying of the belt can be see n, or if the clamps are broken or defor med, replace the seat belt. 1. Check cracks and damage of ROPS (if equipped) and check for loose bolts Check if any bolt is loose or to 1410.4 lbft).

If it is broke then replace it damaged. If it is loose, tighten it (torq ue: 1520 to 19 10 Nm (15 5 to 195 kg