Komatsu — CHECK BEFORE STARTING ENGINE

. OPERATION OPERATION 3 - 67 CHECK WHEEL HUB NUTS, TIG HTEN Check fo r loose hub nuts, and if any are loose, tighten 2 or 3 ti mes to the sp ecified torque in the ord er given in the diagra Tightenin g torque: 18 Nm (123 ± 12 kgm , 1210 ± 1 (When th read and nut seat are not coated with grease 927 ± 10 3 Nm (94.5 ± 10.5 kgm (When t hread and nut seat e grease) disulphid Insert a s ocket wrench in a pipe, and apply a force of 1 210 N (123 kg) at a point 1 m from the fulc (123 kgm ).

rum to give a tightening torque of of 1210 Nm If any stu d bolt used to install the rim is broken, replace all the stud bolts for t CHECK CENTRAL WARNING LA MP Carry out the following checks t o prevent warning failu res caused by a bro operation ken lamp bulb in centr of the buzzer. al warning lamp (1) or defective If there i carry out s any problem, please inspection. ask your Komatsu distributor to Stop t he engine, turn the star ting switch to the ON position, set the pa shift le flashe rking brake valve lever to the PARK position , move the ver to any position oth er than N, and check. If the lamp is normal.

the specified pressure, the lamp amp s and buzzer sounds, it If the air pressure is below flash and the buzzer is turned ON. amp should switch should sound when the starting CHECK BRAKING EFFECT Check if the braking capacity of the parking brake, foo t brake , and retarder If any ab normality is found, ask Komatsu distributor to repair.