Komatsu — PRECAUTIONS BEFORE TRAVELING AFTER LONG-TERM STORAGE

. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING AFTER STORAGE 3 - 113 BEFORE STORAGE (more than one month), store as follows. ried, house the machine in a dry building. Never leave it outdoors. When keeping in long-term storage After every part is washed and d ried, house the machine in a dry building. Never leav In case it is indispensable to leav e it outdoors, park the machine on the flat ground and cover it with ca nvas etc. Completely fill the fuel tank. Thi s prevents moisture from collecting. ore storage. hydraulic cylinder piston rod with grease.

Lubricate and change the oil bef Coat the exposed portion of the Disconnect the negative terminal s of the battery and cover it or remove it from the machi ne and store it se parately. Set the parking brake valve leve r to the PARKING position to apply the parking brake. Set the tire inflation pressure for each tire to within the range of the specified inflation pr essure fo r the ty pe of tire.

Open the drain valve of the air ta nk, release the air, then tighten the drain valve again Push the retarder control lever fo Place the gear shift lever at the To prevent corrosion, be sure to f ill the cooling system with Supercoolant (AF-NAC) or p ermanen t type a ntifreeze (density between 30% and 68%) . If it is necessary to perform the rust-pre vention operation while the machine is indoors, open the do ors and windows t o improve ventilation and prevent gas poisoning. During the storage period, operate the machine once a month to prevent loss of the oil fil m at the l ubricat ed parts. At the same time, charge the batter y. ipe off the grease on the hydraulic piston rod.

Before operating the dump body, w ipe off the grease on the hydraulic piston rod NOTICE If the machine has been stored without carrying out the monthly rust-prevention operation, consu lt your Komatsu d istributor before using it. When using the machine after long -term storage, do as follows before using it. raulic cylinder rods. on points. Wipe off the grease from the hyd Add oil and grease at all lubricati When the machine is stored for a long period, moisture in the air will mix with the oil. Che ck the oil before and after starting the engine. If there is w ater in the oil, change all the oil. PRECAUTIONS BEFORE TRAVELING AFTER LONG-TERM STORAGE 1.

Check all the oil and water levels before traveling. 2. When traveling after long-term storage, travel forward at a speed of 10 to 15 km/h (6.2 to 9.3 MPH) for 5 minutes or 1 km to run the machine in, then change to normal travel. 1. Check all the oil and water leve 2. When traveling after long-term s or 1 km to run the machine in, t torage, travel forward at a speed of 10 to 15 km/h (6.2 to 9.3 MPH) for 5 minutes hen change to normal travel.