. OPERATION TROUBLESHOOTING 3 - 126 CHASSIS ( ): Always contact your Komatsu distributor when dealing with these it ems. In cases of problems or causes which are not listed below, contact your Komatsu distributor for repairs. Problem Main causes Remedy Torque converter oil temperature monitor flashes ( Check, repair) ( Check, repair) Add oil to specified level. See CHECK BEFORE STARTING Replace belt. See EVERY 500 HOURS SERVICE ( Clean or replace) Drive in direct range ( Repair, connect wiring) Steering wheel is heavy Add grease ( Replace cylinder seal) Steering wheel pulls Make tire inflation pressure uniform.
See CHECK BEFORE STARTING Check wear of front brake pad For details, see EVERY 500 HOURS SERVICE Braking effect is poor when brake pedal is depressed ( Replace pad) ( Replace pad) Charge to specified pressure Add brake oil. See CHECK BEFORE STARTING Bleed air See WHEN REQUIRED Brake pulls to one side Dump body speed is slow ( Replace gear pump) Add oil to specified level. See CHECK BEFORE STARTING Suspension is hard ( Replace U-packing) ( Replace valve core) Wheel on one side tends to slip Bleed air from rear brakes (left, right). See WHEN REQUIRED ( Replace tires) Make load uniform ( Disassemble and adjust brake)