. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 5. Install the cleaned element, then install cover (3). 4 - 24 2. Remove outer element (5). interior and the cover. less then 0.69 MPa (7 kg/cm2, 99.4 3. Clean the air cleaner body 4. Direct dry compressed air ( PSI)) along the folds of the with air along the folds fro again from the inside. 1) Remove one seal ever 2) Replace the outer elem repeatedly or used thr element at the same ti 3) Replace both inner an indicator red piston a cleaned outer elemen cleaned 6 times. 4) Remove evacuator valv air. After cleaning, inst element from the inside. Next, blow m the outside, then blow with air y time the element is clean.
ent if it has been cleaned 6 times oughout a year. Replace the inner me. d outer elements when the dust ppears soon after installing the t even though it has not been e (4) and clean it with compressed all it again. NOTICE If small holes or thinner parts are f ound on the element when it is checked with an electric bulb after cleaning and drying, replace the element. hit it or beat it against something. s or gasket or seal are damaged. When cleaning the element, do not Do not use an element whose fold REPLACING INNER ELEMENT the outer element, and then remove the inner element. e (outlet side) with a clean cloth or tape. interior, then remove the cover installed in Step 2. to the body.
inner element. d the cover. 1. First remove the cover and 2. Cover the air connector sid 3. Clean the air cleaner body 4. Install a new inner element Do not clean and re-use an 5. Install the outer element an 6. Remove evacuator valve ( 7. After replacing the element 1. First remove the cover and the outer element, and then remove the inner 2. Cover the air connector sid e (outlet side) with a clean cloth or tape. 3. Clean the air cleaner body interior, then remove the cover installed in S 4. Install a new inner element 5. Install the outer element an 6. Remove evacuator valve ( 4) and clean it with compressed air. After cleaning, install it 7.
After replacing the element , return the red piston in the dust indicator to its original po