. MAINTENANCE SERVICE PROCEDURE CHECK ALTERNATOR BELT TENSION, ADJUST CHECKING 4 - 48 The deflection shoul d be 13 to 16 mm ( 0.5 to 0.6 in) w hen a point midway between the drive pulley and a y is pressed with the thumb with a force of 98.1 N (1 ADJUSTING ounting bolts (6) (2 places), and remove the 1. 2. 3. 4. 1. Remove cover m ounting bolts (6) ( cover. 2. Loosen bolts and nuts (1), (2) and (5 ), then turn nut (4) to adjust the tension of the belt. 3. After adjusting, ti ghten bolts and nu ts (1), (2) and ( 5) to secure alternator (3). 4. Reinstall the cov er removed in step 1. Confirm th at no part of the cover touche s any moving part of the alternat or.
REMARK Check each pulley for breakage and wear of the V- groove. In particular, check that the V-b elt does not touch the bottom of the V-gr oove. is found, ask your Komatsu distributor for replacement of the pulley. engthened that it cannot be adjusted any more or if it has any cuts or cracks, replace it. If any abnormality is found, ask your Komatsu distr If the V-belt is so l engthened that it c annot be adju sted any more or if it has any cuts or c If the V-belt has b een replaced with a new part, ther e will be initial elongation, so inspect an d adjust it again after one-hour of opera tion.