Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE TRANSMISSION OIL FILTER ELEMENT WARNING cause burns. Wait for the Run the engine at high idling, and when the oil is warmed up, if the transmission filter (valve end) clogging clean the inside of the case and 3. Install the new element, then install cover (2) with bolt (1). 4 - 58 T he parts and oil are at high temperature immediately after the engine is stopped, and may starting the work. p, turn it slowly to release the internal pressure, then remove it. temperature to go down before When removing the oil filler ca p, turn it slowly to release the int VALVE INLET SIDE the oil under the filter case. 1. 2. 3. 4. 5. 1. Set the container to catch 2.

Remove drain plug (1) at th e bottom of the filter case, dr ain the oil, then tighten the plug a gain. 3. Hold down case (2), loose n center bolt (3), then remov e case (2). clean the inside of the case. nd O-ring with new parts. Coat the 4. Remove the element and Replace the filter gasket a nd O-ring with new parts. Co 6. Assemble the new elemen t to the case, set the case in position, and install with cente Be careful not to tighten c Tightening torque: 167 to o 144.7 l bft) 7. Run the engine for a short time at idling, then stop the e ngine, an d check that the oil is up to the specified level. For details, see "CHANG (PAGE 4-65)".

E OIL IN TRANSMISSION CASE, CLEAN TRANSMISSION CASE STRAINER monitor lamp flashes, repl ace the element immediately. RETURN SIDE 1. Remove bolt (1), then rem 2. Take out the element, the removed parts. Run the engine at high idling, and when the oil is warmed u p, if the t ransmission filter (ta nk end) clogging monitor lam p on the maintenance mon itor (if equipped) flashes, rep lace the element immediately.