Komatsu — METHOD OF USE

. ATTACHMENTS, OPTIONS REVO TACHOGRAPH (TCO 15-7) METHOD OF USE 1. Open the cover. Insert the instrument open/lock key in hole (1), turn counterclockwise 90 ° , then pull open carefully. The cover can be opened approx. 115 ° . Do not open it further than that, or pull it strongly, or put anything heavy on the cover, as these will cause failures. 2. Set the time. Turn time setting knob (2) to set the time. Always set the time with the time setting knob. Turn the hand in the direction of rotation 10 minutes beyond the correct time, then turn back to the correct time. Check the clock operation with the movement of minute hand. The clock is electric, so there is no need to wind it up. 6 - 23 3.

Fill in chart. Before inserting new chart etc.) Fill in the above items with paper, always fill in the required items. (O perator code No., m achine code No., date, a steel pen. Handle the charts carefully wit h clean hands, and do not fold or scratc 4. Removing used charts Push down pressing ring (3 where it contacts the stopp ) holding the charts, turn counterclockwise, a nd pull out the pr essing ring at the point er, then remove the charts. Handle the charts carefully wit h clean hands, and do not fold or scratc 5. Insert new chart. Remove pressing ring (3), shaft (5) on the right.

When exactly with red point (6) o then set the charts under cutting knife (4), and below fan-shaped rotating transfer doing this, align the time on the charts ( for example when th e starting time is 9 am) n the instrument body. Precautions when replacing th e charts When aligning the charts with t he center of the chart support, do not fo rce them into positio n or use your finger to make the hole in the center of recording. the chart paper larger. If the size of the hol e changes, it ma Stop the engine completely be Use Komatsu genuine charts ( P/N: YZ762929-730) for 90 km/h (55.9 MPH 6. Close the cover.

Lift up the cover to close it, remove the instrument ope then turn the instrument open/lock key 9 0° clockwise. When operating the machine, n/lock key.