Komatsu — TROUBLESHOOTING

. ATTACHMENTS, OPTIONS OPERATION OF ABS AND ABS/ASR PRECAUTIONS FOR USE WARNING 6 - 30 If the ABS functions wh ile traveling on a slippery road, the braking distance may be slightly lengthened. Even if the ABS is turned on, the tires ma y lock when the machine is braked when running at a very low speed. Accordingly, take ca re when driving on slippery road s. If the machine is brake d while running at high speed or on a slippery road, more air is consumed by the ABS/ASR. If the air pressure drops and th e warning buzzer sounds, stop the machine in a safe place. Wait until the air pressure is restored gain.

restored sufficiently, then start a Even with the ABS/ASR system installed, there may be instances where the machine can not travel safely such as o n a road having an extremely lo w coefficient of friction (a frozen road, etc.) or on a s teep slope. In this case, repair the road surface before driving. The machine can be travel normally even if the ABS/ASR main switc h is turned off. In this case, however , watch out for lateral skiddin g of the machine. Even if the ABS/ASR system malfunctions, the machine can be trav el normally. Watch out for lateral skid ding in this case, however, while traveling on slippery roads.

If the warning lamp lights up, the system is automatically turned off and the AB S/ASR system does not function. ion is maintained. ressed or the retarder control lever pulled, does not indicate a fault. Even if the ABS/ASR system is installed, the secondary brake funct If the ABS/ASR mai n switch is turned on with the brake pedal dep exhaust sound will b e momentarily emitted from the ABS valve. This If both rear wheels sl ip at the same speed, the ASR will not function . In this case, adjust the engine outp ut with the accelerator peda l.

When installing a wir eless device on the machine, select one which does not violate the wireless device-related laws/regulations and use it according to law. Mount it as far away from the devices and wiring harness of the possible. ABS/ASR system as TROUBLESHOOTI NG When the starting sw itch is turned on, if the warning lamp does not lig ht up, it may be broken. In this case, replace the lamp. If the ABS/ASR syste m malfunctions while being used, the warning l amp (Red) will light up. In this case, s top the machine at a safe pl ace immediately, then ask your Komatsu distrib utor to carry out repair.

The positions of each s witch and the statuses of the corresponding wa A Starting switch M BS/ASR Warning lamp ain switch OFF OFF Goes off OFF ON Goes off ON OFF Lighted (Normal) ON Stays lighted until travel speed rises to about 10 km/h (6.2 MPH), ON then goes off (Normal). Lights up when a fault occurs (Malfunction).