. ATTACHMENTS, OPTIONS ARSC (AUTOMATIC RETARDER SPEED CONTROL) No. Code Condition 1 0.0 When accelerator pedal is being depressed ("." is not shown for 0 on the right) 2 0.0. When accelerator pedal is not being depressed ("." is shown for 0 on the right) REMARK If the above code is not displayed when the accelerator pedal is being depressed or not being depressed, it is necessary to adjust the accelerator link. If it is not properly adjusted, the ARSC system will not be able to judge correctly if the accelerator pedal is being depressed or not, so the ARSC may not work normally.
METHOD OF DISPLAYING MODEL SELECTION, TIRE LARGE DIAMETER/SMALL DIAMETER, FAILURE CODE When the starting switch is turned ON, the codes below are automatically displayed in the following order on the controller LED. 1. LEDs all light up. 2. Model Code: 32 3. Tire diameter Code: -- 4. Latest failure code 5. Failure code that occurred immediately before the failure code in 4. 6. Failure code that occurred immediately before the failure code in 5. METHOD OF CLEARING FAILURE CODE Turn machine starting switch to ON (the engine is not started) and disconnect connectors CR1 and CR2 under the assistant's seat. When this is done, " " is displayed on the controller LED.
When the " " changes from flashing and stays lighted up (3 seconds), the failure code has been cleared. REMARK When using the ARSC for the first time, always clear the failure codes. After clearing the codes, connect connectors CR1 and CR2. 6 - 44 WHEN SYSTEM IS NORMAL The code is displayed on the controller LED under the assistant's seat.