Komatsu — Toggling Through Warning Screens

OM3232 8/11 Operator Cab And Controls - Section 32 Page 32-21 Toggling Through Warning Screens Warning Screens OK Note: If a switch having no defined function for the current mode is actuated, the message "INVALID ENTRY" will be displayed on the screen while the switch is being pressed. Switch 1 Switch 2 Load = 240 t LC = 25 TT = 6000 t Load = 240 t ˆ This newest fault becomes inactive before being displayed. A new fault becomes active. OK The highest priority fault becomes inactive. A new lower severity fault with a lower priority operator action becomes active. A new higher severity warning with a higher priority action becomes active. PWR CHK All warnings have now been OK'd.

OK Notice that this one OK acknowledges both faults simultaneously OK OK Both faults clear. ˆ 2x ˇ A new lower severity warning with a lower priority action becomes active. PRESS DISPLAY A new warning with a lower priority action becomes active. ENG 80412 Load = 240 t LC = 25 TT = 6000 t 3560.9 h SC = 20 mph A warning becomes active. MULTIPLE WARNINGS PRESS OK STOP: PARK: RUN ENG BATT CHARGING FLT A155 CLEARED - 0 ACTIVE 3560.9 h SC = 20 mph Last active standard display with added warning reminder HOT HYD OIL LR A196 PRESS OK STOP: PARK: RUN ENG LC = 25 10,000 m TT = 6000 t SC = 20 mph MULTIPLE WARNINGS PRESS OK STOP: PARK:

RUN ENG CIRCUIT BREAKER FLT A100 PRESS OK HOT HYD OIL LR A196 1 of 1 STOP: PARK: RUN MULTIPLE WARNINGS PRESS OK GO TO SHOP NOW MULTIPLE WARNINGS PRESS OK STOP: PRK: MULTIPLE WARNINGS PRESS OK STOP: PARK LOW STRG PRES A111 2 of 2 STOP: PARK This warning becomes inactive. CIRCUIT BREAKER FLT A100 1 OF 2 LOW STRG PRES A111 2 of 2 STOP: PARK LOW STRG PRES A111 CLEARED - 1 ACTIVE Continue to display inactive fault warning for 10 seconds or until OK'd. New operator action is shown. STOP: PARK: RUN CIRCUIT BREAKER FLT A100 CLEARED - 0 ACTIVE HOT HYD OIL LR A196 1 of 2 STOP: PARK HOT HYD OIL LR A196 1 of 1 STOP: PARK:

RUN SNAPSHOT IN PROG A234 CLEARED - 1 ACTIVE Display each warning that went inactive without being displayed with the "FAULT CLEARED" message. They are displayed in the order in which they became inactive. GO TO SHOP NOW The last remaining fault becomes inactive. HIGH FUEL TEMP C261 CLEARED - 0 ACTIVE MULTIPLE WARNINGS PRESS OK STOP: PARK: RUN HOT HYD OIL LR A196 CLEARED - 0 ACTIVE Load = 240 t LC = 25 TT = 6000 t 3560.9 h SC = 20 mph