Lubrication and Service - Section 40 9/11 OM4057 Page 40-14 500 HOUR LUBRICATION AND MAINTENANCE (Cont.) 8. 9. 10. 11. 12. 13. 14. 15. BLADDER ACCUMULATORS - Check the precharge pressure. Failure to maintain the correct precharge pressure may result in bladder failures. HVAC a. Ensure the air conditioner cab drains are clear of any obstructions. b. Also wash the air conditioner condensor with a low pressure hose. Check for any obstructions to airflow, clean as required. KOMTRAX Plus DATA DOWNLOAD - Perform a data download from the KOMTRAX Plus controller and send the data to WebCARE. Refer to the shop manual for more detailed instructions.
GRID BLOWER SHAFT BEARINGS - Add one or two applications of grease to each grease fitting. Ensure that each bearing is receiving grease. Replace bearings if any wear is detected. (Lube Key G) CONTROL CABINET COOLANT - Check the coolant level of the drive system controller inside the control cabinet. Coolant must be visible in the middle of the upper sight gauge. FRAME AND AXLE BOX INSPECTION - Wash the truck, clean all of the weld joints, and visually inspect the entire frame and axle box for cracking or damage. RETARDING GRID - Visually inspect grid resistors for damage by looking in the grid box outlet, replace resistors if necessary. MAIN BLOWER a.
Check that the motor is clean and that the interior is free of any dirt or oil. b. Verify the terminal box is sealed, reseal and add sealent as necessary.