Komatsu — Lubrication Cycle Operation

Automatic Lubrication System - Section 42 10/10 OM4212 Page 42-10 SYSTEM CHECKOUT To check system operation, proceed as follows: Main Level Screens 1. Remove the dust covers from the injectors. OK 2. Start the engine. 2100 rpm SC = 20 mph 3. Actuate the manual override button at the pump assembly and observe pin movement at each injector. ˆ ˇ Switch 1 Switch 2 4. Check for pump, hose or injector damage or leakage with the system under pressure. ˆ ˇ 5. After checking system, stop the engine. Observing normal precautions regarding high voltage present in the propulsion system before attempting to repair lube system. ˇ ˆ 6. Re-install the injector dust covers.

ˇ Advance to screen 1 if moving and no realtime data. Lubrication Cycle Operation Advance to screen 4 . Screen 5 ˆ The time between lube events is determined by the setting selected in the dash panel. Refer to Figure 42-7 for lubrication menu screens. With the key switch ON, scroll through the display menu screens and select either 8, 15, 24 or 30 minutes between lube cycles. The default setting is 15 minutes. Realtime Data OK to View (future development) ˇ Advance to screen 1 if moving. ˆ ˇ NOTE: Turning the key switch to the ON position will not initiate a lube cycle.

To initiate a lube cycle while the truck is stationary, select manual lube using the dash display panel, or use the switch on the lubrication pump. ˇ The truck must be moving before the lube system will initiate lube cycles based on the time interval selected. ˆ ˇ OK Manual Lube Screen 9, subscreen max. ˆ Screen 9, subscreen 0 Press OK to Start ˆ ˇ OK Lube Interval 8 15 24 30 Screen 11, subscreen max. ˆ Screen 11, subscreen 0 Press OK to Edit 80414 FIGURE 42-7.

LUBRICATION MENU Screen 1 Load = 240 t LC = 25 TT = 6000 t Screen 2 Load = 240 t LC = 25 TT = 6000 t 10,000 m SC = 20 mph Screen 3 Load = 240 t LC = 25 TT = 6000 t 3560.9 h SC = 20 mph Screen 4 1 Active Warnings Press Advance to screen 5 OR screen 4 OR screen 3. ˆ Screen 6 Payload Data OK to View Screen 7 1 Repair Item OK to View Screen 8 2 Maintenance Items OK to View Screen 9 System Controls Press OK to View Screen 10 English Español Français OK Portuguese Screen 11 Configure System Press OK to Edit