OM2041 9/11 Safety - Section 20 Page 20-5 Fire Prevention Mirrors, Windows And Lights Remove wood chips, leaves, paper, and other flammable items that have accumulated in the engine compartment. Failure to do so could result in a fire. Remove any dirt from the surface of the windshield, cab windows, mirrors and lights. Good visibility may prevent an accident. Adjust the rear view mirror to a position where the operator can see best from the operator's seat. If any glass or light is broken, replace it with a new part. Check the fuel, lubrication, and hydraulic systems for leaks. Repair any leaks. Clean any excess oil, fuel or other flammable fluids, and dispose of them properly.
Make sure that the headlights, work lights, and taillights are in proper working order. Make sure that the truck is equipped with the proper work lamps that are needed for the operating conditions. Make sure that a fire extinguisher is present and in proper working condition. Do not operate the truck near open flames. In Operator Cab (Before Starting The Engine) Do not leave tools or spare parts lying around. Do not allow trash to accumulate in the cab of the truck. Keep all unauthorized reading material out of the truck cab. Ventilation In Enclosed Areas Keep the cab floor, controls, steps and handrails free of oil, grease, snow and excess dirt.
If it is necessary to start the engine within an enclosed area, provide adequate ventilation. Inhaling exhaust fumes from the engine can kill. Read and understand the contents of this manual. Pay special attention to Sections 30 and 32 pertaining to safety and operating instructions. Become thoroughly acquainted with all gauges, instruments and controls before attempting operation of the truck. Read and understand the WARNING and CAUTION decals in the operator's cab. Make sure that the steering wheel, horn, controls and pedals are free of any oil, grease or mud. Check the operation of the windshield wiper, condition of wiper blades, and the washer fluid reservoir level.
Preparing For Operation Always mount and dismount while facing the truck. Never attempt to mount or dismount the truck while it is in motion. Always use handrails and ladders when mounting or dismounting the truck. Be familiar with all steering and brake system controls, warning devices, road speeds and loading capabilities before operating the truck. Check the deck areas for debris, loose hardware and tools. Check for people and objects that might be in the area. Seat Belts On both driver and passenger seats, check the seat belt fabric, buckle, all belt retractors and hardware for damage or wear. Replace any worn or damaged parts immediately.
Become familiar with and use all protective equipment devices on the truck and ensure that these items (anti-skid material, grab bars, seat belts, etc.) are securely in place. Even if there are no signs of damage, replace both driver and passenger seat belts 5 years after seat belt manufacture, or every 3 years after start of use, whichever comes first. The passenger seat belt date of manufacture label is sewn into the seat belt near the buckle. The driver seat belt date of manufacture label is sewn into the shoulder harness belt, near the retractor end.