OM1070 9/11 Introduction - Section 10 Page 10-3 ABOUT THIS MANUAL The front cover of this manual includes a form number. This form number should be referenced when ordering additional copies of this manual or for any other correspondence regarding the coverage in this manual. Direct all inquiries to: Komatsu America Corp. Technical Publications - Mining Equipment P.O. Box 240 Peoria, IL 61650-0240 (309)-672-7072 - FAX This first section is an Introduction to the manual. It contains the Table of Contents for locating specific areas of interest. Other sections include:
Standard Charts and Tables Safety Warnings and Cautions Operating Instructions Operator Cab and Controls Lubrication and Service Automatic Lubrication System Major Component Descriptions/Specifications Payload Meter III Radio, AM/FM Stereo Cassette When searching for a specific area of interest, go first to the Table of Contents to locate the section in which the subject might generally be included. Then, find a subject description that most closely describes the specific area of interest and go to that page. Section numbers and page numbers are located at the top, outside corner of the page. At the top, inside corner of the page is a document (module) number.
If there is ever a question regarding the information in a particular section, refer to the document (module) number, the manual form number, and use the address shown above to correspond. If there is a date (month/year) behind the document (module) number, that date indicates the latest revision date of that page. The illustrations used in this manual are TYPICAL of the component shown and may not be an exact reproduction of what is found on the truck. This manual shows dimensioning of U.S. standard and metric (SI) units throughout. All references to “right,” “left,” “front,” or “rear” are made with respect to the operator's normal seated position unless specifically stated otherwise.
When assembly instructions are provided without references to specific torque values, standard torque values should be used. Standard torque values are shown in torque charts in the Standard Charts and Tables section in this manual and in the General Information section of the truck shop manual. Specific torques, when provided in the text, are in bold face type, such as 135 N•m (100 ft lbs) . All torque specifications have ±10% tolerance unless otherwise specified.