. OPERATION OPERATION CHECK COOLANT LEVEL, ADD COOLANT WARNING and loosen caps slowly to release radiator pressure, then remove the caps. 3 - 89 Do n ot remove caps (1) or (2) while coolant is hot. Hot coolant may spurt out and cause serious injury. When removing cap (1) or (2) wait un til the coolant temperature goes down 1. Open the side cover on left s ide of the machine and check that th e coolant level in reserve tank (3) is between the FULL and LOW lines. If the coolant lev el is low, add coolant as follows. 2. When adding coolant, add through both caps (1) and above bottom of the straine (2). Check that the coolant is r as shown in diagram on the righ t.
At the same time add coolant to th e FULL line in the reserve tank through cap (3). 3. To refill the radiator, first sto p the engine and pour coolant until it r eaches the top of the fille r opening. Then start the engine, after idling for 5 minutes rech eck the coolant level, add coolant if n n radiator caps (1) and (2), then ed is more than usual, check for ks. 4. tighten reserve tank cap (3). 5. If t he volume of coolant add possible cooling system lea Do not rely solely on the mon itor for checking the coolant l evel.