. OPERATION OPERATION ADJUST ARMREST (LEFT) 1. When adjusting height of both armrest and case It is possible to effortlessly adjust the standard height up 50 mm (2 in) or down 50 mm (2 in). Turn up/down left adjustment knob (1) to adjust the height. Turn the knob to adjust as follows. Turn CLOCKWISE to move UP Turn COUNTERCLOCKWISE to move DOWN Open the armrest, and turn knob (2) counterclockwise to adjust the height. Only the armrest will move up. After adjusting it to the desired height, close the armrest. 3 - 104 The armrest on the left side o f the operator's compartment ca n be adjusted to and gearshift lever moves as a u nit. 2.
When adjusting height of armrest only It is possible to effortlessl from the armrest and cas The steering, directional, y adjust up to 36 mm (1.4 in) upward e contact surface. and gearshift lever does not move. and gearshift lever does not mov 3. By carefully adjusting to match the operator's physique, i t is possible to operate the tr and smooth steering) an adjust the armrest as follo 1) Sit in the operator's up-down adjustment console assembly to the top surface of the the right. 2) Next, operate the trav knob (2) to adjust the thickness of the ope operate smoothly to t the support at the fron avel lever correctly (with fine control d comfortably (with little fatigue), so ws:
seat, grip the travel lever, and turn knob (1) to adjust the height of the urn the a position where the elbow matches armrest as shown in the diagram on el lever to the left and right, and t urn height of the armrest to match the rator's arm so that it is possible to he left and right using the elbow and t.