. OPERATION OPERATION OPERATIONS AND CHECKS AFTER STARTING ENGINE WARNING WARMING UP OPERATIONS 3 - 115 If th ere has been any Emergency sto p, abnormal actuation or trouble, turn the starting switch key to t If the work equipment is operated wi thout sufficiently warming the machine up , response of the work eq uipment to movement of th e control lever will be slow, an d the work equipment may not respond a s the operator desires, so always perform the warming-up operation. Particularly i n cold areas, be sure the warming-up ope NOTICE Do n ot perform operations or suddenly operate the levers when the hydraulic oil is at a low temperatur operation until the hydraulic oil temp e.
Always perform the warming-up erature monitor displays the green rang e. This will help extend the mac hine life. Do not suddenly accelerate the engi operating temperature. ne before the machine reaches full Do n will ot run the engine at low or high cause oil leaks from the turboch idle for more than 20 minutes. This arger oil supply piping. If it i s necessary to run the engine at idling, apply a load from time to time or run the engine at a mid-rang e speed. (3) flashes or the buzzer sounds heck for the cause. If en gine oil pressure caution lamp intermittently, stop the engine and c 1.
Tu rn fuel control dial (1) to the center position between LOW ID me LING (MIN) and HIGH IDLIN G (MAX) and run the engine at dium speed for about 5 min utes with no load.