. OPERATION OPERATION 3 - 147 METHOD OF OPERATING PIN PULLE lower 1. Stop the machi ground. Operate 2. ntroller position and re move t he m ounting pin. 3. Move the ripper up or down to set t o the desire d shank position. shank to to the 4. Operate t he pin puller contr ol switc h to i nsert t he mounting pin. I s s f the pin does not match th e position o f the h ole in the shank, et th e p in pull er control s witch to the PUSH position and lowl y move th e rippe r up o r down REMARK When raising the pin position to increase the digging depth, use a long protecto r to pr event wear of the shank .