. OPERATION OPERATION ADJUSTING RIPPER 1. Place a pointed object on the tip of pin (1), then hit with a (PAGE 3-147)". 3 - 154 ADJUSTING DIGG Mounting pin hole s are provided in the shank and t hese are u sed according to the desired di gging depth . For no use, use the bott om hole, and when p articularly d eep diggin g is needed, use the top hole. For the method o f changing the depth of digging, see "METH OD OF OPERATING PIN PU LLER (PAGE 3-14 move from the oppos ite side. 2. Remove pin ( 2) and change the po sition of th e shank ho 3. Insert pin (1) partially by hand then knock it in with a ha mmer. made of one piece, s hand it in with a hammer.
ant ripper is installed, use the pin , see "METHOD OF OPERATIN G PIN PU LLER REPLACING POINT AND PROTECTOR To protect the sh nd point in are worn, replace Place a pin remo ver on the pin marked by the arr ow, then h it with a hammer to rem ove from the opposit e side. REMARK The pin is a unitiz ed type, so insert the pin partial ly by hand , then knock it in fully w ith a hammer.