. MAINTENANCE GUIDES TO MAINTENANCE 4 - 3 DUSTY WORKSITES: as follows: When working at dusty worksites, do Clean the radiator fins and other p arts of the heat exchange equipment more frequently, and take care not to let the fins become clogged. ntly. cially the starting motor and alternator, to avoid accumulation of dust. Replace the fuel filter more freque Clean electrical components, espe cially the starting motor and alternator, to avoid accumulation of du When checking and replacing the o il or filters, move the machine to a place where there i s no dust and take care to prevent dust from entering the s ystem. AVOID MIXING OILS:
If a different brand or grade of oil has t o be added, drain the old oil and replace all the oil with the new bran d or grade of oil. Never mix different brand or gr ade of oil. LOCKING INSPECTION COVERS: position with the lock bar. If inspection or maintenance is performed with Lock inspection cover securely into inspection cover not locked in positio n, there is a danger that it may be suddenly blow shut by t he wind a nd cause injury to the worker. BLEEDING AIR: When hydraulic equipment has been repaired or replaced, or the hydraulic piping has been removed an d installed again, the air must be bled from the 4-43)". circuit.
For details, see "BLEEDING AIR IN HYDRAULIC SYSTEM (PAGE PRECAUTIONS WHEN INSTALLING H YDRAULIC HOSES: where there are O-rings or gasket seals, clean the mounting surface, and forget to assemble the O-rings and gaskets. When removing parts at locations replace with new parts. When doing this, be careful not to When installing the hoses, do not twist them or bend them sharply. If they are installed so, t heir servi ce life will be shortened extremely and they may be damaged. CONTROLLER:
The controller for the machine monito r may be actuated mistakenly by radio wave interference f rom the o utside, so when installing any radio control equi pment to the machine, please consult your Komatsu distributor. CHECKS AFTER INSPECTION AND M AINTENANCE: If you forget to perform the checks afte r inspection and maintenance, unexpected problems may occur, an d this may lead to serious injury or property dam age. Always do the following: e stopped) enance points been forgotten? nance items been performed correctly? ropped inside the machine? It is particularly dangerous if parts are dropped ght in the lever linkage mechanism. nt or oil? Have all nuts and bolts been tightened?
operating the engine, see "PROPER TOOLS (PAGE 2-29)" and pay careful ance items working properly? il when the engine speed is raised? Checks after operation (with engin Have any inspection and maint Have all inspection and mainte Have any tools or parts been d inside the machine and get cau Are there any leakage of coola Checks when operating engine For details of the checks when attention to safety. Are the inspection and mainten Is there any leakage of fuel or o 2-29)" and p ay careful