Komatsu — LUBRICATING

. MAINTENANCE SERVICE PROCEDURE EVERY 250 HOURS SERVICE Blade arm ball joint (4 places) - U (4) Brace screw (2 places) 4 - 48 LUBRICATIN 1. Lower t he work equipme nt to the ground, then stop the engine. 2. Using a grease pump, p ump in grease through the grease 3. After gr easing, wipe off any old grease that wa s pushed out.

(1) Blade lift cylinder suppor t yoke (4 places) (2) Blade lift cylinder suppor t shaft (2 places) (3) Blade ar m ball joint (5 pl aces) - Semi U (5) Ripper ti lt cylinder bottom pin (2 places) (6) Ripper li ft cylinder bottom pin (2 places) (7) Ripper ti lt cylinder rod en d pin (2 places (8) (9) Ripper li Ripper a ft cylinder rod en rm pin (front) (2 (10)Ripper a rm pin (rear) (2 The illustrat ion on the right s hows Giant Ripper (if equipped)