. MAINTENANCE SERVICE PROCEDURE CHECK ALTERNATOR DRIVE BELT TENSION, ADJUST CHECKING ADJUSTING adjust the 15 mm (0.59 in) REMARK 4 - 50 The standard de flection for the drive belt is approx . 15 mm (0.59 in) whe n pressed b y thumb (approx. 5 8.8 N {6 kg}) a t a point midway between the driv e pulley and altern 1. L oosen bolts and nuts (1), (2) a 2. Turn nut (4) clockwise, then m ove alternator elt tension so that the deflecti when pushe d with a force of 6 k Whe n adjusting the belt tension, ne ver push the alternator directly with a bar. If it is necessary to push the alternator , insert a piece of woo d in-betwee n and push it with a 3.
Tighten the b olts and nuts (1), ( 2) and (3) to fi x alternat or (5) in osition. 4. Check for da mage to the pulley s, and wear o f the V-gr oove and V-belt. Be particularly careful to check th at the V-belt is not in contact with the bottom of the V-groov 5. I f any belt h eplace the b 6. After replaci ng the belt, operate for one hour , then adj ust again