. SAFETY PRECAUTIONS FOR OPERATION BATTERY flush the with large 2 - 24 BATTERY HAZARD PREVENTIO N phuric acid, and batteries generate flammable hydrogen gas, which may explode. Battery ele ctrolyte contains sul Mistaken h andling can lead to s erious injury or fire. For t his reason, always observe th e following precautions. When th e battery electrolyte i s below LOWER LEVEL, don't either use or charge the battery. Otherwise, that may cause e xplosion. Always carr y out periodic checks of th e battery electrolyte, and add distilled water up to UPPER LEVEL. For the method of checking t he battery electrolyte, see "CHECK LEVEL OF BATTE RY ELECTROLYTE (PAGE 4-51)".
When w rubber g Never s moke or use any flam If you s pill acid on your clot area wit h large amount of wa If acid g amount ets into your eyes, of water and seek m Before working with batteries , turn the starting switch to position As there is a hazard that spark s will be generated, alway s do as follows. Do not l et tools or other metal objects make any contac t between the battery terminals . Do not leave tools or other metal o bjects lying around n ear the battery. When d isconnecting the batt ery terminals, wait for app rox. one minute after turning o ff the engine starting switch key, an d be sure to disconne ct the grounding terminal (negative (-) terminal) first.
Co nversely, when connecting them, b egin with the positive (+) terminal and then the grounding (-) terminal. Make s ure that all the terminals are connect ed securely. securely. Tighten the battery terminals Flamma ble hydrogen gas is g enerated when the batter y is charged, so remove the b attery from the chassis, take it to a w ell-ventilated place, a nd remove the battery ca Tighten the battery caps sec Install t he battery securely to