. OPERATION EXPLANATION OF COMPONENTS Lever (8) position can be adjusted to best suit the operator's 3. Tighten lock bolt (1) with the wrench to hold lever (2) in position. Adjustment within range of 40 mm (1.6 in) from neutral to front 3 - 49 ADJUSTING FRONT-REAR POSITION OF RIPPER CONTROL LEVER (Range of adjustme nt: ± 40 mm (1.6 in physique. Follow th e steps below for th e adjustme Adjustment withi n range of 40 mm ( 1.6 i n) f rom neutral to rear 1. Loosen lock nut ( 1) with a wrench. 2. Set lever (2) to th e optimum position 1. Remove lock bolt (1) with a wrench. ° 2. Remove lever (2) and reverse it 180 3. Install lever (2) to lever (5), then set it to the optimum position. 4.
Tighten lock bolt ( 1) with the wrench to hold lever (2) i n position. 5. Loosen nut (3). 0°. 6. Reverse knob 18 7. Tighten nut (3). PIN PULLER CONTROL SWITCH (IF EQUIPPED Switch (9) is used to operate the pin pu ller. (a ) PULL OUT: Pin i (b ) PUSH IN: Pin is DUST INDICATO R aner bracket inside the engine room. s that the air cleaner element is clogged. This is on the air cle aner bracket inside the engine room This device indicate s that the air clean er element is clogged. For details on how AND REPLACE AIR to clean the element, CLEANER ELEMENT see "CHECK, (PAGE 4-26)" CLEAN .