(9) Take ring, bearing races and needle bearing from sleeve and spool. The outer (thin) bearing race can sometimes "stick" in the housing, therefore check that it has come out. (780-3A) 5-74(1) Press out the cross pin. Use the special screw from the end cover. (10) (780-3A) 5-74(2) ц A small mark has been made with a pumice stone on both spool and sleeve close to one of the slots for the neutral position springs (see drawing). If the mark is not visible, remember to leave a mark of your own on sleeve and spool before the neutral position springs are disassembled. (780-3A) 5-74(3) Carefully press the spool out of the sleeve. (11) (780-3A) 5-74(4) 5-34