Service Manual for WD10 Diesel Engine (2) Clean up the fitting surface between crankcase and engine oil pump intermediate gear module. (3) Install the seal ring in intermediate gear. (4) Install engine oil pump intermediate gear (convex side face inward). (5) Install intermediate gear shaft. (6) Install and tighten the hexagon bolt. 494 Disassembly, Inspection, Maintenance and Assembly of Engine Oil Filter 4941 Exploded View of Engine Oil Filter Engine oil filter Engine oil filter assembly seat gasket Hexagon socket cap screws Fig.
4-68 Exploded view of engine oil filter 4942 Steps to Disassemble Engine Oil Filter Remove the four bolts on engine oil filter and take down engine oil filter assembly and filter seat gasket. As shown in Fig. 4-68. 4943 Inspection and Maintenance of Engine Oil Filter (1) Check the engine oil filter assembly for damage, replace it if necessary. (2) Check the engine oil filter seat gasket for damage, replace it if necessary. 4944 Steps to Assemble Engine Oil Filter (1) Before the assembly, check engine oil filter assembly and filter seat gasket, make sure there is 108 Wave spring washer Hexagon socket cap screws