Service Manual for WD10 Diesel Engine (2) A/C compressor doesn’t work after A/C is turned on Possible causes and maintenance methods for A/C compressor working failure are listed in Table 4-3. Table 4-3 Troubleshooting for A/C compressor working failure (3) Precautions for maintenance of A/C compressor 1) After disassembling of A/C system, all parts should be sealed in time. Removed parts of A/C system cannot be exposed to air for long time, in order to prevent moisture in the air infiltrating into A/C compressor system. 132 4 The belt is too tight, which leads to vibration of A/C compressor Adjust the belt tension, it is suitable if the belt is depressed 10~14mm after loading 10kg force.
5 Misalignment of pulley shafts, or the belt is not on the same plane, which leads to vibration of A/C compressor Reassemble the compressor to keep the shafts aligned and belt on the same plane. 6 Loose compressor fastening bolts; loose or damaged support Tighten the bolts; replace compressor support. 7 Compressor internal part is damaged Replace the compressor. 8 Excessive coolant leads to vibration of high pressure pipe, and compressor produces knocking noise Drain out the coolant until high pressure gauge indicates normal. Problem: A/C compressor doesn’t work S/N Possible cause Maintenance method 1 A/C switch failure Check, repair or replace the switch.
2 Clutch coil failure or loose connector Tighten the connector, replace the clutch. 3 Low voltage or clutch coil burnout due to short circuit, which leads to clutch fail to pull-in or slipping Find out the cause for low voltage, increase the voltage or check the circuit, replace the compressor if there is short circuit. 4 Loose or breakage of belt Adjust or replace the belt. 5 High-low pressure switch failure or open circuit Check the switch, find out what caused the open circuit, and replace if necessary. 6 Excessive clutch air clearance Replace the compressor. 7 Clutch pulley doesn’t rotate Replace the compressor. 8 Compressor internal part is damaged Replace the compressor.