Weichai — Weichai WD10 Diesel Engine Service Manual

Service Manual for WD10 Diesel Engine worn or damaged, whether connecting rod bolts are loose; check whether air compressor main oil gallery is unblocked; replace the severely worn or damaged bearing shells, sleeve and main bearing shell; tighten connecting rod bolts to 35Nm~40Nm; unblock the main oil gallery with compressed air. 2) Check whether the driving and driven pulley groove type is uniform, replace if not. Adjust the belt tightness degree (press the belt with your thumb, it is suitable if the belt is depressed about 10mm).

3) Check engine oil pressure (air compressor oil inlet port), check whether engine oil pipe is damaged or blocked, adjust, clean or replace the invalid pipe if the oil pressure is insufficient; Check engine oil quality and impurity content, compare it with application standard, replace the oil immediately if out of limits; check whether there is engine oil supplied to air compressor, conduct a comprehensive inspection if not. 4) Check whether compressor fixing bolts are loose and tighten them. 5) For gear-driven compressor, check the fitting condition of the gears, tighten loose nuts, and replace the gear if there is fitting problem. 6) Clean up foreign matter.

(5) Air compressor “burning” Fault phenomenon: For belt-driven compressor, its main shaft is locked; for gear-driven compressor, the bearing shell or connecting rod bearing shell is abnormally loose. Possible causes: 1) The lubricating oil is deteriorated or too many impurities in the oil. 2) Insufficient oil supply or no oil supply. 3) Compressor inner oil channel is blocked by misplaced bearing shell. 4) Damaged bearing shell or connecting rod bearing shell, or too small fit clearance. Troubleshooting:

1) Check engine oil quality and impurity content, compare it with application standard, replace the oil immediately if out of limits; 2) Check engine oil pressure (air compressor oil inlet port), check whether engine oil pipe is damaged or blocked, adjust, clean or replace the invalid pipe if the oil pressure is insufficient; 3) Check installation position of bearing shell, oil hole on bearing shell should be aligned to housing oil hole. 4) Check whether bearing shell and connecting rod bearing shell are damaged, check whether crankshaft is damaged or worn when replacing or repairing the shell. 142