Service Manual for WD10 Diesel Engine 3) Poor cleanliness of steering system, leads to overwear and ablation of steering pump stator and rotor module, and produces noise. 4) Blockage, twisting or huge deformation of oil pipe results in poor oil supply, or poor system matching leads to resonance. Troubleshooting: 1) Check steering system (oil cup, pump, steering gear and pipelines) for oil leakage. 2) Check steering system oil cup (including filter screen and oil level) for air, bubble and blockage problem. 3) Use echoscope to detect the noise source (oil cup, pump, steering gear and pipelines). 4) Check steering system oil temperature at normal idle engine speed.
Cool the system if the temperature is high, and replace the damaged parts. (4) Troubleshooting of other steering pump faults Steering pump gear teeth collision “Driving gear collision” is mainly caused by dynamic balance failure. Main cause for dynamic balance failure is improperly installed steering pump (steering pump driving gear and engine driving gear are not concentric). Elimination method: Detect the dimension and material of driving gear, steering oil pump manufacturer is responsible for the disqualification. If the gear is qualified, refit the pump. Steering pump shaft breakage “Shaft breakage” is mainly caused by dynamic balance failure.
Main cause for dynamic balance failure is improperly installed steering pump (steering pump driving gear and engine driving gear are not concentric). Elimination method: Detect the dimension and material of driving gear, steering oil pump manufacturer is responsible for the disqualification. If the gear is qualified, refit the pump. Steering pump housing cracking Cracking of steering housing back cavity, main cause for this failure is improper sealing of steering pump oil inlet and outlet joints, directly lead to infiltration of impurities and blockage of filter screen and damping hole, then result in steering pump safety valve failure and high system pressure.
1) Applied thread seal tape when installing oil inlet and outlet joints, the thread seal tape blocked filter screen and damping hole. 2) “Flat gasket + thread sealant” seal style is applied, too much thread sealant went into damping hole and blocked it, and result in steering pump housing cracking——We suggest no thread sealant. 150