Service Manual for WD10 Diesel Engine surface, and push the pump (with a sealing gasket) into the mounting hole gently, ensure the helical gears are normally engaged and steering pump flange face should be parallel with the fitting surface, loose-fit the pump with two M10 hexagon bolts and wave spring washers, and tighten the bolts diagonally with 16mm open end wrench (or double offset ring spanner) to 50~60Nm, make sure not to damage the sealing gasket in this process. As shown in Fig. 4-93. (2) Two applicable connecting types of oil inlet and outlet joints: copper washer (or combination flat gasket) and O-shape ring. Thread seal tape or thread sealant is strictly prohibited.
(3) Steering pump oil inlet and outlet joint screwing-in length should be suitable, neither too short nor too long. Refer to Fig. 4-94 and Fig. 4-95. Screwing-in length is too long, oil inlet Screwing-in channel is length is suitable blocked Fig. 4-94 Oil inlet joint screwing-in length is too long Screwing-in length is too long, damping hole is blocked Screwing-in length is suitable Fig. 4-95 Oil outlet joint screwing-in length is too long 152