Service Manual for WD10 Diesel Engine 3212 Excessive Noise 3213 Starter Motor Doesn’t Work 28 9. Severe wear of parts, overhaul needs to be done Check working hour of engine, overhaul the engine. 10. Crankshaft and the follower main shaft are not concentric Check the installing support, repair. 11. The applied engine oil quality fails to meet the requirements Choose specified engine oil brand. 1. Inferior fuel Replace the fuel. 2. Too low cooling water temperature Check the thermostat and replace it if necessary. 3. Incorrect valve or injection timing Check and adjust it. 4. Bad atomization Check and repair. 5.
Overmuch fuel pumped by the injection pump Check and adjust (should be performed by professional personnel). 6. Wear of damper Check connecting bolts for damage and replace damaged parts. 7. Air leakage of valve or maladjustment Overhaul the valve and adjust. 8. Excessive gear clearance or gear tooth breakage Check and replace damaged parts. 9. Wear of piston or cylinder sleeve, or scuffing of cylinder bore Overhaul piston and cylinder sleeve, repair or replace. 10. Bended or fractured pushrod Replace. 11. Breakage or wear of piston ring Check or replace the damaged parts. 1. Undercharged battery Check, recharge or replace the battery. 2.
Bad contact Clear up the circuit and tighten all terminals. 3. Fuse blow Replace the fuse. 4. Bad contact of electric brush Clean the brush or replace it. 5. Short circuit in starter motor Overhaul the motor or replace it.