Weichai — Weichai WD10 Diesel Engine Service Manual

Service Manual for WD10 Diesel Engine Fig. 4-8 Depth micrometer Refer to Table 4-1 for valve recession requirements. If valve recession exceeds allowed range, check wear condition of valve and valve seat, replace the valve with a new one to determine wear condition of valve seat by measuring the valve recession again, if the valve recession still exceeds allowed range, the cylinder cover must be replaced to ensure reliability of diesel engine. If valve recession doesn’t exceed allowed range, disassemble the valve to check the sealing surface between valve and valve seat for obvious wear and abnormal damage. Table 4-1 Valve recession requirements:

(4) After disassembling valve mechanism, check cylinder cover intake and exhaust passage for water leakage and other problem, if leakage is discovered, liquid penetrant test should be done after cleaning to locate the problem, replace the cylinder cover. (5) Clean cylinder cover, focus on combustion chamber surface, valve seat, intake and exhaust valve, intake and exhaust passage, remove the carbon deposit and mucilage glue, and check the surface condition. (6) Check valve guide pipe inner diameter.

Due to internal surface of valve guide pipe is the contacting surface between valve rod and valve guide pipe, if clearance between valve rod and valve guide pipe exceeds allowed value due to abrasion, then the guide effect will at state, which may affect reliability of the engine. The inner diameter of guide pipe can be measured with an inside micrometer, as shown in Fig. 4-9. Allowed range for inner diameter of guide pipe is 11~11.018mm. If it exceeds allowed range, the cylinder cover must be replaced to ensure reliability of diesel engine. Fig. 4-9 45 Required value of valve recession (mm) Intake valve 0.85~1.05 Exhaust valve 1.08~1.48