Service Manual for WD10 Diesel Engine 2) Rub-up cylinder sleeve inner wall and apply clean engine oil on the wall; Clean up upper surface of cylinder block, and place cylinder gaskets correctly by aligning the holes; 3) Check and make sure the holes on cylinder cover gasket are correctly aligned to holes on cylinder block. (3) Install valve rod seal cartridges Spring Fig.
4-12 Valve rod seal cartridge 1) Valve rod seal cartridges are disposable, and should be replaced once removed; 2) Check valve rod seal cartridge for flaws, check whether valve rod seal cartridge spring is in good condition; 3) Install valve rod seal cartridge on valve guide pipe; 4) Apply lubricating oil on valve rod seal cartridge lip; 5) Use dedicated assembling tools and rubber hammer to assemble valve rod seal cartridge assembly. Dedicated assembling tool Valve rod seal cartridge Valve rod guide pipe Cylinder cover Fig.
4-13 Assembling of valve rod seal cartridge (4) Assemble cylinder cover 1) Clean up the cylinder cover carefully, make sure there is no dust, debris and sand, and rub-up undersurface of cylinder cover; 47