Service Manual for WD10 Diesel Engine 6) Tighten cylinder cover main bolts with torque wrench orderly to 200Nm and mark the bolts; 7) Tighten each cylinder cover auxiliary nut for further 90° with torque wrench orderly and mark the new position of the nuts; 8) Tighten each cylinder cover main bolt for further 90° with torque wrench orderly and mark the new position of the bolts; 9) Tighten each cylinder cover auxiliary nut for another 90° with torque wrench orderly and the tightening torque should reach 120~160Nm; 10) Tighten each cylinder cover main bolt for another 90° with torque wrench orderly and the tightening torque should reach 240~340Nm; Fig.
4-15 Assembly of cylinder cover auxiliary nuts and clamp blocks Fan side Flywheel side Fig. 4-16 Tighten number 1~7 cylinder cover auxiliary bolts (studs) 49