Service Manual for WD10 Diesel Engine 4343 Inspection and Maintenance of Gear Housing Key point 1: Assembling: Tighten gear housing fastening bolts according to the following order crosswise. Fig. 4-24 Key point 2: Assembling: Check whether seal ring is damaged, replace it if so. When assembling, seal ring should be applied with oil and fully pressed into seal groove, protect the ring in this process. Key point 3: Disassembling: When disassembling gear housing, firstly take down gear housing fastening bolts, and then remove intermediate gear shaft and engine oil pump intermediate gear shaft. The removed gear housing should be placed in clean environment. Assembling:
Insert intermediate gear shaft into the gear and then place the assembly into gear housing; Apply sealant on cylinder block water inlet and outlet ports and press-in the seal rings. 4344 Steps to Assemble Gear Housing Assembling steps are contrary to disassembling ones. 58 Tightening torque 44~58Nm