Service Manual for WD10 Diesel Engine 44 Crank-Rod Mechanism 441 Disassembly and Assembly of Crank-Rod Mechanism 4411 Exploded View of Crank-Rod Mechanism Main bearing bolt Crankcase Main bearing shell Crankshaft Pulley Flywheel Flywheel bolt Flange Bearing Pulley bolt Flywheel housing Engine block Piston-rod assembly Fig. 4-32 Exploded view of crank-rod mechanism 4412 Steps to Disassemble Crank-Rod Mechanism (1) Check before disassembling.
Check connecting rod axial backlash, check tightening torque of connecting rod bolts; Tilt and lay the engine on its side, rotate the flywheel until the to-be removed piston is in BDC, remove connecting rod bolts and cap; Rotate the flywheel until the to-be removed piston is in TDC, knock the piston out with wooden hammer, proceed with caution to avoid jamming cylinder block with connecting rod big end. Remover other pistons in the same way, number and place them orderly. (2) Screw off front end pulley bolts, take down the pulley and damper. (3) Screw off flywheel bolts, take down flywheel assembly, bearing, etc.
4413 Steps to Assemble Crank-Rod Mechanism Assembling steps are contrary to disassembling ones. 66 Connecting rod big end cap Flywheel ring gear Crankshaft timing gear Damper