Weichai — Weichai WD10 Diesel Engine Service Manual

Service Manual for WD10 Diesel Engine 446 Disassembly, Inspection, Maintenance and Assembly of Crankshaft Bearing Shell 4461 Exploded View of Crankshaft Bearing Shell Main bearing upper shell Crankshaft Main bearing lower shell Fig. 4-40 Exploded view of crankshaft bearing shell 4462 Steps to Disassemble Crankshaft Bearing Shell Push the shells out with hand, and mark the removed shells (should be corresponded with fitting holes on engine block and crankcase). 4463 Inspection and Maintenance of Crankshaft Bearing Shell (1) Clean the bearing shells and check their wear condition. (2) Check and ensure there is no peeling, locating lip damage and transverse crack on the shell.

4464 Steps to Assemble Crankshaft Bearing Shell (1) Clean up main bearing shells and the fitting holes. (2) If no shell is replaced, then install the two shells into engine block (upper) and crankcase (lower) respectively (pay attention to the mark, shells should be installed into corresponding holes on engine block and crankcase), do not mix upper and lower shells, the one with oil groove is upper one. The shell lips should be aligned and applied with engine oil. 75