Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION ADJUSTMENT SEAT ADJUSTMENT WARNING (A) Fore-and-aft adjustment Move lever (1) up and move the seat to the desired position and release the lever. Fore-and-aft adjustment: 210 mm (10 mm x 21 stages) (8.3 in (0.4 in) x 21 stages) (B) Adjusting seat angle Move lever (2) up, move the seat cushion at the front up or down to set to the desired position, then release the lever. Amount of adjustment Forward tilt: 3 degrees Rear tilt: 11 degrees (C) Adjusting seat height The seat height adjustment uses an air system, and it can be 3 - 83 Park the machine in a safe pl ace and stop the engine when carrying out adjustment of the operato r's seat.

Adjust the seat position at th e beginning of each shift or when operators change. Adjust the seat so that the br ake pedal can be depressed all the wa y down with the operator's bac k against the backrest. An air compressor built into t he seat is used for adjustment (C) a nd (D), so turn the engine s tarting switch to the ON position before starting the a djustment. NOTICE There is danger of damage to th e air compressor, so do not keep lever (3) operated continuously for adjusted steplessly. When adjusting the height, fully (when pulling it up, pull i set at the desired height, re pulled up, the position where the seat does not rise any furthe the maximum height.

When t the suspension automatical amount of movement of the l If the operator raises his bod y from the seat or changes the amount of weight applied to the seat during adjustment, the air in the suspension ma y be discharged. m (3.2 in) Amount of adjustment: 80 m REMARK If lever (3) is pulled up further from the maximum height, the air compressor may make a so und of actuation but the seat may not rise. This does not indicate any abnormality. ressor will stop automatically after approx. 8 seconds. It will also stop if lever (3) is If this happens, the air comp pushed down.