Komatsu — CLEAN INSIDE OF COOLING SYSTEM

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE on radiator cap (2) to water until the 4 - 24 2. release the p ressure before removing 3. Prepare a c ontainer to catch the s uper coolant an mixture, then open drain plugs (3) an d (4) of the radia drain the wa 4. After drainin g the coolant , close drain plugs (3) and (4) with tap wate 5. When the ra diator is full, start the engi ne, and run it at Keep the en gine running at low idle for 10 minutes coolant temp erature reaches more th an 90°C (194°F) 6. Stop the eng ine, open drain plugs (3) a nd (4) to drain th 7. Close drain plugs (3) and (4). et valve (1) to the ON position to open it.

acing the corrosion resistor, see REPLACE CORROSION RESISTOR ant additive into a mixing container and mix it thoroughly. 8. Replace the corrosion resistor, then s et valve (1) to th e ON position For details o f the procedure for repl E (PAGE 4-52). CARTRIDG 9. Put the supe rcoolant, water, and cool ant additive into a mixing container and mix it tho For details o f the ratio fo r mixing sup ercoolant and w ater, see "WATER, SUPERCOO LANT, AND ADDITIVE MIX RATIO TABLE". lant mixture made in Step 9 through the water filler up to the bottom of the filler port. 10. Pour the coo lant mixture made in Ste p 9 through the water fille r up to the bottom of the 11.

To bleed the air from the cooling syst em, run the engi ne at low idle f or 5 minutes, and fo r a further 5 minutes at high idle. (W hen doing this, leave the radiator cap off. ) 12. Stop the eng ine, wait for approx. 3 mi nutes, then add tap wate r until the water level is n ear the water filler port, and tighten t he cap. Check the coola nt level and add water if n ecessary.