. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE (7). 4 - 58 6. Remove hen remove t he cover. Wh en doing this, ho ld the cov er down when removin g the bolts to p force of Remove spring (5). spring (5) an Chec then k that there is n clean the inside 9. Instal l a new element, then set bypass valve (6), s pring (5), and cover (4 ) in the filter ca se. When doing this, if th e cover O-ring is damaged or deterio rated, replace th e O-ring. 10. Hold down the cover a nd tighten the m ounting b olts uniformly. 11. Run t he engine at idle for a short time , then che ck that the oil is up t o the specifi ed level. For details, see "CHECK TRANSMISSION OIL LEVEL, ADD O IL (PAGE 4-25)".