www.changlin.com.cn 5/16 Inch Install the cover and gasket onto the fuel injection pump. NOTE: Extreme care must be taken in assembling the cover to a fuel injection pump to make sure the shutoff arm is in proper with the linkage hook tab. Install the cover to pump at a downward angle from the drive shaft end of the fuel injection pump, then slide the cover horizontally into position. Torque Value: 4.6 N*m [41 in-lb] KSB Replacement T30 TORX, 12 mm Disconnect the wiring harness from the KSB solenoid (1). Disconnect the fuel lines (2). Replace the KSB, fuel lines and wiring harness. Torque Value: Fuel Line Banjo Fittings:
12 N*m [9 ft-lb] KSB Mounting Nuts 9 N*m [7 ft-lb] KDB Temperature Switch Replacement 27 mm Disconnect the KSB (1) wiring harness (2) from the switch (3). Replace the temperature switch. Install the wiring harness. Torque Value: 24 N*m [18 ft-lb] Fuel Pump‐Replacement Preparatory Steps: Remove all fuel lines. Remove control linkage. Remove fuel shut off solenoid. 109 / 167 pages