Cummins — HG130, HG170 Engine Manual

www.changlin.com.cn NOTE: A diesel engine cannot tolerate dirt or water in the fuel system. A tiny piece of dirt or a few drops of water in the injection system may stop your unit. Clean all external surfaces of the injection pump, including all line connections and fittings that are to be disconnected. Clean the area around the injection pump gear cover to prevent dirt from entering the crankcase. Removing the Fuel Pump Locate TDC for cylinder number 1. Push the TDCpin into the hole in the camshaft gear while slowly barring the engine. To prevent damage to the timing pin, be sure to disengage the pin after locating TDC.

14 mm Loosen the CAV injection pump lockscrew and position the special washer, then tighten the lockscrew against the pump drive shaft. Torque Value: 7 N • m [5 ft-lb] 3/8 Inch Loosen the Stanadyne DB4 fuel injection pump lock screw and position the special washer. Tighten the lock screw until contact is made with the fuel injection pump drive shaft. Torque Value: 12 N • m [9 ft-lb] 111 / 167 pages