www.changlin.com.cn 10 mm Caution: Alternately tighten the mounting capscrews. As the capscrews are tightened, the fuel transfer pump plunger is pushed into the pump. Failure to tighten the capscrews in an even manner can result in the plunger being bent or broken. Install the pump. Torque Value: 24 N • m [18 ft-lb] High Pressure Fuel Lines‐Replacement Preparatory Steps: Clean debris. 8 mm, 17 mm, and 19 mm NOTE: If individual lines are to be replaced, remove the support clamp from the set of lines containing the line to be replaced. Disconnect the line (s) from the injectors. 19 mm Disconnect the line (s) from the fuel pump. NOTE:
If removed, reinstall the support clamp in the original position and make sure the lines do not contact each other or another component. Install a protective cover on the injectors and fuel delivery valves to prevent the entry of dirt into the system. Install the lines in the reverse order of removal. Torque Value: (Line Fittings)30 N• m [22 ft-lb] (Support Clamp)6 N • m [4 ft-lb] (Support Bracket)24 N • m [18 ft-lb] Fuel Drain Manifold-Replacement Preparatory Steps: 122 / 167 pages