www.changlin.com.cn Injectors-Replacement Preparatory Steps: Thoroughly clean around the injectors. Remove the high pressure fuel lines. Remove the fuel drain manifold. 24 mm Remove the injectors. Injector Bore Brush Clean the injector nozzle bore, using Service Tool No. 3822509. Lubricate the sealing lips of the sleeve with anti-seize compound. Package the injector, sealing sleeve, a new copper sealing washer and the hold down clamp. Use only one washer Service Tip: A light coat of clean 15W40 engine oil between the washer and injector can help to keep the washer from falling during installation. 124 / 167 pages