www.changlin.com.cn Drive Belt Inspection Inspection 3/8 Inch Square Drive, 13 mm Remove the drive belt. Lift the tensioner to remove and install the belt. NOTE: After the tensioner has been raised to remove/in- stall the belt, check the torque of the tensioner cap screw. Torque Value: 43 N*m [32 ft-lb] Inspect the belt for damage. Transverse (across the belt width) cracks are acceptable. Longitudinal (direction of belt length) cracks that intersect with Transverse cracks are not acceptable. Replace the belt if is has unacceptable cracks, if frayed or has pieces of material missing. 56 / 167 pages