19-106 19-106 Electrical System Troubleshooting Inspection 1: Inspect for continuity and short circuiting of the harness. Ignition key switch OFF, disconnect A21 Standard: Inspection 2: Inspect for continuity and short circuiting of the harness. Ignition key switch OFF, disconnect A21 Standard: Error code 72-4 Disconnect the battery negative terminal, after inspecting and correcting disconnection of A3 and A21 and internal moisture, reconnect all connectors and the battery negative terminal, turn the ignition key switch ON, operate (rotate) the steering and check whether or not there is an error. No error Connector contact defect Error Battery voltage (approx. 12 V) Inspection 1:
Steering angle sensor supply voltage inspection Disconnect the battery negative terminal and A3, reconnect the battery negative terminal, and turn the ignition key switch ON. Approx. 0 V To troubleshooting for 72-1 and 72-2 NG Inspection 2: Harness continuity and short circuit inspection Main harness defect OK SAS/OPS controller defect Inspection 1: Carry out steering angle sensor supply voltage inspection. Standard: Section 19 A21-16 ~ A21-5 Continuity A21-16 ~ A21-5 No continuity A21-16 ~ Frame No continuity A3-1 ~ A3-2 Battery voltage (approx. 12 V)